how-to_‎ > ‎cisco_wlc_‎ > ‎

How to verify a Lightweight AP startup configuration

posted Nov 19, 2013, 2:09 AM by Daniele Albrizio
I needed to verify the startup CAPWAP configuration before delivering a Lightweight AP far far away.

  1. Boot a CAPWAP AP without connecting the network (It takes longer due to 2 or 3 timeout waiting for PHY).
  2. Connect to serial console.
  3. Login verifying the password from controller are successfully stored.
  4. Enter enable.
  5. If you configured a static IP verify it with
    show capwap ip config

    LWAPP Static IP Configuration...
  6. Issue
    show capwap client config
    and search in particular for the following lines
    ...
      mwarName                  wlc.mydomain.it
      mwarIPAddress             8.8.57.215
    ...
      Configured Switch 1 Addr  8.8.57.215

Comments